US Geological
  Survey logo

Effect of Water-Column pH on Sediment-Phosphorus Release Rates in Upper Klamath Lake, Oregon, 2001
By Lawrence H. Fisher and Tamara M. Wood
Water-Resources Investigations Report 03-4271
Prepared in Cooperation with the Bureau of Reclamation
 
  Download the report
Report cover

Abstract    

Sediment-phosphorus release rates as a function of pH were determined in laboratory experiments for sediment and water samples collected from Shoalwater Bay in Upper Klamath Lake, Oregon, in 2001. Aerial release rates for a stable sediment/water interface that is representative of the sediment surface area to water column volume ratio (1:3) observed in the lake and volumetric release rates for resuspended sediment events were determined at three different pH values (8.1, 9.2, 10.2). Ambient water column pH (8.1) was maintained by sparging study columns with atmospheric air. Elevation of the water column pH to 9.2 was achieved through the removal of dissolved carbon dioxide by sparging with carbon dioxide-reduced air, partially simulating water chemistry changes that occur during algal photosynthesis. Further elevation of the pH to 10.2 was achieved by the addition of sodium hydroxide, which doubled average alkalinities in the study columns from about 1 to 2 milliequivalents per liter.

Upper Klamath Lake sediments collected from the lake bottom and then placed in contact with lake water, either at a stable sediment/water interface or by resuspension, exhibited an initial capacity to take up soluble reactive phosphorus (SRP) from the water column rather than release phosphorus to the water column. At a higher pH this initial uptake of phosphorus is slowed, but not stopped. This initial phase was followed by a reversal in which the sediments began to release SRP back into the water column. The release rate of phosphorus 30 to 40 days after suspension of sediments in the columns was 0.5 mg/L/day (micrograms per liter per day) at pH 8, and 0.9 mg/L/day at pH 10, indicating that the higher pH increased the rate of phosphorus release by a factor of about two. The highest determined rate of release was approximately 10% (percent) of the rate required to explain the annual internal loading to Upper Klamath Lake from the sediments as calculated from a lake-wide mass balance and observed in total phosphorus data collected at individual locations.

Contents

Introduction
    Objectives
    Acknowledgments
Methods and Materials
    Sample Collection
    Experimental Design
    Analytical Methods
Results
    Stable Interface Study
    Resuspended Sediment Study
    Phosphorus Fractionation Study
Discussion
Summary
References Cited
Appendix: Summary of Data Quality



Download the report (PDF, 1 MB) (Adobe PDF Reader required; version 5 or higher preferred.)
If you do not have the Adobe PDF Reader, it is available for free download from Adobe Systems Incorporated.
Document Accessibility: Adobe Systems Incorporated has information about PDFs and the visually impaired. This information provides tools to help make PDF files accessible. These tools convert Adobe PDF documents into HTML or ASCII text, which then can be read by screen-reading programs that synthesize text as audible speech. In addition, a version of Acrobat Reader 6 that contains support for screen readers is available. The conversion tools and the accessible reader may be obtained free from Adobe at Access Adobe.

Order a printed copy of this or other USGS water-resources reports.
For information about other USGS Klamath Basin studies, please visit the project Web site.
To find out more about the USGS in Oregon, please visit our home page.


[an error occurred while processing this directive]
U.S. Department of the Interior, U.S. Geological Survey
Persistent URL: http://pubs.water.usgs.gov/wri034271
Page Contact Information: GS Pubs Web Contact
Last modified: Thursday, September 01 2005, 05:12:49 PM
FirstGov button  Take Pride in America button