Lithologic log of drill cuttings for DOGAMI heat flow hole CR-SB, Mount Hood, Oregon
Links
- Document: Report (pdf)
- Download citation as: RIS | Dublin Core
Abstract
CR-SB is one of three shallow (-82.0 m) heat flow holes drilled in 1976 at Mount Hood, Oregon by the Oregon Department of Geology and Mineral Industries (DOGAMI). Drill hole CR-SB was located on the southern flank of the mountain near the Snow Bunny ski lodge at an elevation of 1167.7 m (T 3 S, R 8.5 E, Sec. 25 AA) (Fig. 1). Temperatures, measured at 5.0 m intervals, and geothermal gradient data for the drill hole are given in Hull, Blackwell, and Black (1978) and are reproduced in Table 1 and Figures 2 and 3 in this report. Blackwell and Steele (1979) give an average thermal conductivity, based upon 6 samples of drill cuttings, of 4.53 (standard error =0.26) but indicated that the data obtained from the drill hole are unsuitable for heat flow calculations.
Splits of the drill cuttings were obtained courtesy of J. F. Riccio (DOGAMI). The drill cuttings were wet sieved through a 200 mesh (0.074 mm) screen and both fractions were air dried and saved. Representative rock types and alteration material were hand-picked from the coarse fraction using a binocular microscope. Slurry slides of finely-ground cuttings were routinely run at 1/2°/min. from 3° to 37° 20 using unfiltered CuK radiation on a Norelco 1/ X-ray diffractometer equipped with a focusing monochrometer.
Study Area
| Publication type | Report |
|---|---|
| Publication Subtype | USGS Numbered Series |
| Title | Lithologic log of drill cuttings for DOGAMI heat flow hole CR-SB, Mount Hood, Oregon |
| Series title | Open-File Report |
| Series number | 80-521 |
| DOI | 10.3133/ofr80521 |
| Year Published | 1980 |
| Language | English |
| Publisher | U.S. Geological Survey |
| Description | 10 p. |
| Country | United States |
| State | Oregon |
| Other Geospatial | Mount Hood |